VoIP phone Cisco SPA301-G2

1. Installing your phone.

Connect your phone to the network by using Ethernet cable.

2. Launch a web browser on a computer that can reach the phone on the network.

3. Direct the browser to the IP address of the phone.

Note

To determine the IP address:

Press the Setup button on the phone.

Scroll to Network (9) and press Select. The IP Address is displayed under Current IP (2).

4. You can enter static IP in Network menu, if DHCP is disabled in your network. 

Also you can request for network settings to your system administrator.

5. Enter the IP address in your web browser address bar. There will be opened the phone configuration page.

5. Click Admin Login, and advanced to pass to the advanced settings.

6. Click the System tab in top menu and change your network and internet connection settings. 

You can obtain your network settings from your system administrator. The configuration of internet connection you can obtain from your provider's support.

7. Click button Submit All Changes at the bottom to save your settings.

8. Optional Network Configuration. 

Enter provider's DNS addresses in fields Primary DNS and Secondary DNS.

9. Add information of your SIP accounts (please use tabs Ext 1 - Ext 3).

For example, to configure your SIP account click Ext 1:

Proxy: Enter SIP proxy domain address

Register: Yes

User ID: Enter your SIP ID

Use Auth ID: Yes

Auth ID: Enter your SIP ID

10. Audio Configuration

Please set turned on only codecs G711a and G729a. Other codecs may be turned off.

If you use extension numbers:

Select DTMF Tx Method to AVT to make possible DTMF signals transfer.

11. Click button Submit All Changes at the bottom to save your settings. 

Your VoIP phone is ready to use!